Express Setup Wizard

After logging in to the router, we need to set the related parameters of the WAN port to connect to the Internet and configure Wi-Fi and LAN port to provide internet to other terminals.

Step 0 - Welcome & Timezone

i. How to use the wizard

You can click the “Next” button to continue the next step of the express setup wizard, or click the “Previous” button to return to the previous step. Click “Quite” you will exit the express wizard. You can set up the WAN, 4G, LAN, and Wi-Fi settings afterward.

ii. Time Zone
Choose timezone from the list.

Step 1 - WAN Settings

Generally speaking, we set up a WAN connection at first to allow the router to access the Internet. You can choose the Internet setting according to your situation.

Line type and bandwidth: Recommended to be set to 0.9 to 0.95 of the total bandwidth.

The reserved bandwidth is used to defend against bursty data. In areas with plentiful bandwidth, you can set a factor higher than 0.95.

The total bandwidth of the uplink and downlink is kilobytes per second, that is, KB/s, which is usually calculated by multiplying the nominal bandwidth by 100. For example, 10M fiber, the total bandwidth of the uplink and downlink is 10*100, that is, 1000KB/s. For reserved bandwidth, it is recommended to set 937KB/s.

In general, selecting “Internet access type and bandwidth” will automatically fill in “upstream reference bandwidth” and “reference downstream bandwidth”, and the system will automatically consider reserve and calculate bandwidth. Customization is only required if the appropriate type is not found.

PPPoE dial-up (or ADSL dial-up)

Connection type: PPPoE
Username and password: Provided by the landline carrier
Line type and bandwidth: Recommended to be set to 0.9 to 0.95 of the total bandwidth.

Dynamic IP

Connection type: Dynamic IP
Automatically obtain data flow and IP address from the master router

Line type and bandwidth: Usually non-required

Static IP

Connection type: Static IP provided by the carrier
IPv4 and gateway address: Provided by the landline carrier

Line type and bandwidth: Recommended to be set to 0.9 to 0.95 of the total bandwidth.

Step 2 - LAN Settings

IPv4 address: The router address (gateway address)
Netmask: Adjustable subnet mask
MAC address: MAC address of Ethernet chipsets

4G Mobile Settings

Connection type: Choose Dynamic IP

Some of the mobile carriers require to set up APN before connect to their network

APN: Access point name (APN) is the gateway to access carrier’s network
Username: User name to access mobile carrier’s network
Password: Password to access mobile carrier’s network
Authentication: Normally use PAP
PIN: 4 digit numbers of the PIN code of SIM card

Step 3: Wireless Wi-Fi Settings

Configure the wireless Wi-Fi networks

Disabled: Default is enabled the Wi-Fi networks
SSID: Default SSID start with “ezenos”
Encryption:Default encryption type is without password

Step 4: Complete Setup Wizard

You should “Save & Apply” previous settings on the final step 4.

It will take a few seconds to apply the settings and reboot the router.